A Guide To Troubleshooting a Belt Drive Garage Door Opener


A belt drive garage door opener is just one of the 3 types of door openers available to property owners. Both, the chain is driven and also the screw drive openers, possess their own specific uses and users. Since the garage door one of the largest shifting parts in your home and an entry point for your property, you would like to truly feel convinced that everything is likely to perform the way it should. Troubleshooting something means seeing problems before they happen or enticing what is incorrect so you’re able to mend is quick. Below are a number of problems associated using a belt drive garage door opener & garage door installation Albuquerque to get easy troubleshooting.

Dirty Belts

Dust can accumulate on the wheel that drives the buckle. Clean this out using some atmosphere or a rag. Wipe the belt down itself to keep it from rubbing any filth particles and fraying.

Squeaky Drive

When lowering the garage, a noise or squeak it may be the sign of problems that have emerged. In this case, you need to lightly oil the wheel which turns the belt to keep it turning and free from collecting dirt.

 

Bouncing Door

If the doorway continually starts and stop when you raise it, then your bouncing motion can damage the doorway. This is usually caused by the motor not functioning properly, or something is interfering with the belt drive. Inspect the belt to check for any type of obstruction. If there is nothing that could keep the door out of raising smoothly, you then are having trouble with all the motor itself.

Binding of Belt

After the belt begins to shuffle and never work as smoothly as if it was first installed, it is a sign that something has gotten out of recovery. This is usually a product of the railroad assembly being loose. Tightening the bolts having a ratchet will help ease the binding problem.

Door Closes Difficult

After several uses, you might see the door begins to close tough on the cement floor of the garage. This can be a problem with two different components. The first is that the sensitivity of this force adjustment which is located on the back of the motor housing. Adjust this so that the door will probably settle easily on the ground. The second reason is through a loosening of the radial arm that holds the doorway towards the belt. Gently the bolts onto this and await any wear or elongation of the spool hole.

Door Does Not Open

If you press the opener and nothing happens, you should first check to see that the system is plugged in. Examine the gears which turn the belt assembly to see if you can find obstructions. Clean out the IR sensors to make sure that there are no obstructions. You should also look at to be sure that the manual disconnect has perhaps not yet been pulled. If every one of these issues is in very good operating order, you are going to have an issue with all the motor itself.